Ccna security packet tracer labs
![ccna security packet tracer labs ccna security packet tracer labs](http://cpaleaks.com/wp-content/uploads/Packet-Tracer-labs-for-the-CCNA-exam-Practical-CCNA-tests-2-1024x579.jpg)
To test this configuration, we will login via Telnet again and check the privilege level we will then try to gain access to privilege level 15: Therefore, our configuration on R1 is as follows: line vty 0 4 When you configure an enable password/secret without specifying any level, you are effectively configuring an enable password/secret for privilege level 15. To do this, we can configure an enable password/secret.
![ccna security packet tracer labs ccna security packet tracer labs](http://1rtdn21e2k8w27koup1eiasxspe.wpengine.netdna-cdn.com/wp-content/uploads/102615_0911_CCNASecurit1.png)
The task also requires that an administrator be able to access privilege level 15. For this task, we will assign a privilege level of 2 to the VTY lines. We can use the privilege level line configuration command to change the default privilege level for a VTY line. By default, when we login via Telnet to a VTY line on a Cisco IOS device, we are placed at privilege level 1 as shown below: Since this task specifies that usernames should not be configured, then the only other option we have is to configure the privilege level on the VTY lines. Assume that users will login via Telnet/SSH. In the same way, when the “NOC” user logs in, the user should use the “ enable view NOC” command to access the NOC CLI view. When the “helpdesk” user logs in, the user should use the “ enable view Helpdesk” command to access the Helpdesk CLI view. Create two users on R2 with the following username/password credentials: helpdesk/helpdesk and NOC/NOC.